X Sew-along: Week 2

Here we are at Week 2 — Cutting for Everyone’s Got An X! I hope you had fun picking your fabrics. I was so delighted to see what colours you will be working with! In this post, you will find tips on cutting your X quilt fabric.

You will notice that I have been very generous with the fabric requirements. Many of the cuts we are making are unconventional dimensions, so I wanted to leave plenty of room for errors in cutting. If all your cutting goes well, you will have a good amount leftover! So set these aside and keep them for Week 6 when we do a fun improv challenge.

Tip #1: Swatch Chart.

Use the fabric swatch chart on page 2. Since I purchased my fabric a few weeks back, I had forgotten which goes where. Having this chart will be handy as you cut.

Tip #2: Starch.

Apply spray starch or flattening spray and press your fabric before cutting. This will help keep your strips nice and straight. We will eventually working with bias edges when we trim our quilt top and this added stiffness will help with minimizing distortion.

If you don’t have starch and don’t want to buy any, don’t worry! I made my first two versions of Everyone’s Got an X without. Just handle your fabric as little as possible once it’s cut. Protecting it too much from movement will help, as well as keep any edges from fraying. I have put my cut pieces in a tray.

Tip #3: Use your ruler to measure.

Where possible, use your ruler markings rather than your measurements on your mat to cut. It will give you a more accurate cut. In addition, you will not be consistently cutting on the same spot on your mat for repeated measurements, which will eventually damage your mat.

In the image above, I’ve actually flipped my mat over so that I don’t get distracting grid lines. I am only using my ruler to measure. I needed 3 strips of 1″ x width of fabric so I cut a 3″ strip, then at the 2″ mark, then a last 1″ strip. This allows me to pick up my ruler as little as possible, as well as minimizes me handling the strips.

Tip #4: Be organized.

While we don’t have a lot of pieces for this quilt, you can save yourself trouble later on and label as you go! A simple piece of masking tape can go a long way. In the same vein, label your binding strips and set them aside somewhere safe. Check off each step as you go.

Tip #5: Butt your rulers together.

Yes, butt (my children are laughing in the background). You will have to make one or two cuts across a diagonal that will be longer than your longest ruler. Butt two rulers together to extend your straight edge.

Above: Two rulers are taped together to the left. The ruler on the right are helping me keep their edges perfectly aligned
aking my diagonal cut for Triangles “Y”.

Tip #6: Using prints.

If you are using a print for your background fabric (Fabric A), you will need to pay special attention to how you cut Triangles Y. Stack fabric right sides together, then cut the diagonal to get your triangles in the right orientation.

Mock up for the photo (dimensions do not follow pattern). Two rectangles stacked right sides together and cut on the diagonal.
The desired result: Four Triangles Y in this orientation.

There we have it! Once you’ve cut everything, be sure to handle everything as little as possible to prevent distortion and fraying. I got a pretty tray for this purpose, in an on-brand colour! Be sure to post your progress with the hashtag #EveryonesGotAnX!

2 thoughts on “X Sew-along: Week 2

  1. Anja @ Anja Quilts says:

    Hey viewers…make sure you stack fabrics right side together before cutting your triangles….ask me how I know LOL Can’t wait to get my fabrics cut.

Leave a Reply

Your email address will not be published. Required fields are marked *